asterisk_bridge_link_interface

URI – USB Radio Interface

• Connect two-way radio to PC
• Fast and easy!
• $$ Very low cost $$
• USB Interface – no need to open PC case
• Open source: asterisk, app_rpt
• Connect to radio’s interface connector
• Optional configuration EEPROM
• High-quality full-duplex audio
• Optional high level op-amp
• 3 User I/Os

More information is available at:
http://dmkeng.com/Products.htm

Yes! The USB FROG/OB is still around too.

usbfob.pdf

From the qrvc.com web site the following features are mentioned:

chan_usb radio contains all of the interface code to interface app_rpt to a CM108 based USB sound fob.
In addition it contains DSP code to do CTCSS encoding and decoding, squelch, pre-emphasis and soft
limiting, de-emphasis, and audio level adjustments.

Basically, you only need to make 3 or 4 connections to your radio:

• Discriminator audio, de-emphasized audio, or speaker audio.
• Transmit audio (direct to modulator, or microphone)
• PTT

A new doorway is quickly opening to continue the progression of Asterisk as the way to interconnectivity.

For more details about Asterisk app_rpt visit http://app-rpt.qrvc.com/

and information about Asterisk can be found at http://www.asterisk.org

FXS — Foreign Exchange Station

FXO — Foreign Exchange Office

An FXS device initiates and sends ringing voltage. FXS sends the voltage to an FXO device, which receives it.

The phone receiving the call is the last FXO device in the chain, and when it receives voltage from an FXS device, the phone will ring.

Connect the outside line to an FXO port on your Asterisk server to receive voltage from the outside lines.

Connect the phones to FXS ports on your Asterisk server. When the FXO module in your Asterisk Server receives the voltage, it will then generate voltage using the FXS module and send it to your analog phone.

Hint: Remember the “to”… FXS = FX(to)Station and FXO = FX(to)Office.
       With “to” representing the direction taken by the signal.

This is the place to go for support.